RackMaker app icon

RackMaker

Tad Cox

★ 0.00 ratingsProductivity$4.99

iPhone Screenshots

App screenshotApp screenshotApp screenshotApp screenshotApp screenshotApp screenshotApp screenshotApp screenshotApp screenshot

Description

RackMaker works out your conduit bending marks and shows you exactly where each one goes. RACK CHARTS Enter a rack once and get the marks for every conduit, staggered so parallel offsets, kicks and 90s keep their spacing through the bend. Mix conduit sizes, space by center to center or by gap, see the total rack width, and check it against the space you have to fit in. The chart warns you when conduits would touch or run into each other in the bend. EVERY COMMON BEND 90° stubs, offsets, rolling offsets, kicks and kicked 90s, 3-point saddles (10-20-10, 15-30-15, 22½-45-22½ and 30-60-30), 4-point saddles, back-to-back 90s, two 45s around something in a corner, and segmented and concentric bends. RUN BUILDER Put several bends on one stick. Get every mark measured from one end, the cut length, and the order to bend them in. Hold and drag a bend to change the order. DRAWINGS YOU CAN READ Every bend shows the finished shape with its bends numbered, and the straight conduit with each mark and a bender under it, so you can see which way the hook faces and whether the arrow, notch or star goes on the mark. Zoom in on any drawing. ANGLE LEVEL Hold your phone on the bender handle and it reads the angle as you pull. It ticks through the last few degrees, then beeps and buzzes when you are on the angle. MADE FOR THE JOB SITE • Big keypad with fraction keys, so there are no decimals to type • Inches, feet and inches, or centimeters, rounded to 1/8, 1/16 or 1/32 • Handbook multipliers, or centerline radius math for bigger conduit and steeper bends • EMT and Rigid/IMC from 1/2" to 4", with your own bender's deduct, gain and radius • Share any bend as text or a PDF, or print it • Works with no signal. Nothing you enter leaves your phone. No account, no ads, no subscription.